iDevices SOCKET User Manual

Getting Started
Unit Setup
Remove the Socket from packaging.
Note 8 digit pin located on the label and on the
Quick Start Guide.
Screw in your Socket and turn on the power to the socket
Please note that the power to the Socket must always be on.
The Socket will blink blue indicating it is ready to be set up on
the network.
A bulb can be screwed in at any time. By default the Socket
sets the bulb to full brightness.
If using any bulbs other than incandescent only bulbs explicitly
labeled dimmable should be used.

iDevices SOCKET Specifications

General

Brand	iDevices
Model	SOCKET
Category	Transformer
Language	English