iDevices SOCKET User Manual

Socket Doesn't Show Up in the iDevices App
If your Socket doesn't show up after it has successfully been added
to your network, make sure you have the following settings
enabled:!
!
Go to Settings > iDevices. Make sure everything in turned ON. If Home Data
was turned off, turn it on. Cycle your WiFi off, then on again.
Go to Settings > iCloud. Make sure you are logged in to your iCloud account
and Keychain is turned ON
Factory Reset
To reset the Socket to its factory condition, hold down the button
for 10 seconds or more, the unit will momentarily flash red, white
and then restart the setup sequence with a fast blue blink.
Using the Socket without an iOS device
You will have the ability to manually turn the Socket on and off
using the button located on the side if no device is present. You
will not be able to set the brightness of the light bulb or manually
control the LED.
LED Ring Color Codes

iDevices SOCKET Specifications

General

Brand	iDevices
Model	SOCKET
Category	Transformer
Language	English