To Next Page

To Previous Page

AmpliTube X-DRIVE

Interface Mode

Using the interface mode of the pedal you can hook it up to your computer and a monitoring system to jam and

playback music directly from X-GEAR.

You can activate the INTERFACE MODE from the GLOBAL SETUP.

Connect X-GEAR to your computer using the provided USB cable and use the OUTPUT (left channel) and CAB

SIM OUT (right channel) to connect the pedal to a monitoring system such as a power amplifier, active monitors,

or a headphone preamplifier.

AmpliTube (or your DAW) sees the X-GEAR as a regular interface, and you can playback songs from the

computer and jam along using AmpliTube (or the DAW) to monitor your session.

To tweak the volume of the X-GEAR when used as audio interface browse to the GLOBAL SETUP and edit the

INTERFACE VOL parameter. After tweaking the volume for the first time the INTERFACE VOL parameter will be

quickly accessible using the PARAMETER encoder until you select another parameter.

N.B. The headphone output is not really meant to be used in audio interface mode since it’s directly connected

to the CAB SIM OUT therefore it is a mono output, and you would only hear the right channel of your computer.

Use a dedicated monitoring system to monitor while the pedal is in audio interface mode.

IK Multimedia AmpliTube X-DRIVE User Manual

Questions and Answers: