AmpliTube X-SPACE
Global Setup
39
SPILLOVER
Sets the spillover function of the pedal.
• ON: the spillover is active (the tail persists when bypassing a preset).
This option requires the BUFFER BYPASS MODE.
• OFF: the spillover is not active.
USB OUT
Sets what signals are sent to the USB OUT.
• STEREO: the signals sent to the USB OUT are a copy of the Left & Right Outputs.
• DUAL: on USB OUT 1 is sent a copy of the Left & Right Outputs summed to mono, while on USB OUT 2 is
sent the dry clean DI signal of the instrument (bypassing the pedal effect).
BYPASS MODE
Sets the bypass technology for the pedal.
• TRUE: selects the true bypass technology.
• BUFFER: selects the buffered bypass technology. This option is required to use the spillover function and
the cab simulator.
OPERATION MODE
Sets the operative mode of the pedal to be used for live gigs or as an audio interface.
• LIVE: in live mode, the audio signal is taken from the analog jack inputs, processed by the DSP and sent to
all outputs.
• INTERFACE: in interface mode, the signal is taken from the analog jack inputs, processed, and then sent
to the USB outputs to a computer.
Then the signal coming out from the computer goes back into the pedal in its USB inputs and sent to the
Left & Right outputs, which can be connected to a monitoring system.
See the Interface Mode paragraph to learn more.
FACTORY RESET
After a confirmation this option resets the pedal to its factory status.
FW VERSION
Displays the currently installed firmware version.
To Next Page
Loading...
Need help?
General
