AmpliTube X-TIME
Delay Models
12
MOD TAPE
IK’s Tape Echo recreates a modern echo sound with additional modulation controls over depth and speed to
generate movement in the delay repeats, while maintaining all the typical characteristics that make the tape
echo sound so sought-after.
Parameters
• TIME: controls the time of the delay repetitions.
From 60 ms to 2000 ms or from 1/32 to 1/1T when BPM SYNC is ON.
• FEEDBACK: controls the number of repetitions occurring in the delay.
From 0% to 100%.
• FILTER: controls the low-pass filter frequency. Turn it counterclockwise to filter out the high frequencies or
clockwise to get the full frequency spectrum.
From 490 Hz to 19000 Hz.
• MOD: controls the depth of the modulation.
From 0% to 100%
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• MOD RATE: controls the modulation rate.
From 0.1 Hz to 10 Hz
• X-MODE: the X-MODE pushes the feedback to infinity and activates an additional tilt filter to bright up its
tail.
ON or OFF.
MOD TAPE Control Changes
Parameter Control Change # Values
TIME 21 0 – 127
FEEDBACK 22 0 – 127
FILTER 23 0 – 127
MOD 24 0 – 127
MIX 25 0 - 127
MOD RATE 46 0 - 127
X-MODE 13 0 - 127
When a parameter range is not linear its values are equally divided among the 128 steps of a Control Change
value.
To Next Page
Loading...
Need help?
General
