AmpliTube X-TIME
Delay Models
15
PING PONG
This delay is designed to provide the perfect moving ping pong bouncing left and right. In addition to the
standard ping pong pattern, it also features another mode for panning the repeats Left-Center-Right and add a
groovy “circular” effect.
Parameters
• TIME: controls the time of the delay repetitions.
From 60 ms to 2000 ms or from 1/32 to 1/1T when BPM SYNC is ON.
• FEEDBACK: controls the number of repetitions occurring in the delay.
From 0% to 100%.
• FILTER: controls the low-pass filter frequency. Turn it counterclockwise to filter out the high frequencies or
clockwise to get the full frequency spectrum.
From 800 Hz to 20000 Hz.
• MOD: selects the delay mode.
• L-R: the iconic ping pong delay mode with repeats alternating left and right.
• L-C-R: a more sophisticated delay mode with repeats alternating left, center and right.
• MIX: controls the balance of dry and wet signal. At 0% the signal is fully dry, while at 100% the signal is
fully wet. At around 85% the dry and wet signal have the same level.
From 0% to 100%.
• X-MODE: the X-MODE pushes the feedback to infinity.
ON or OFF.
PING PONG Control Changes
Parameter Control Change # Values
TIME 21 0 – 127
FEEDBACK 22 0 – 127
FILTER 23 0 – 127
MOD 24 0 – 127
MIX 25 0 - 127
X-MODE 13 0 - 127
When a parameter range is not linear its values are equally divided among the 128 steps of a Control Change
value.
To Next Page
Loading...
Need help?
General
