IKEA LIVSLAGA User Manual

ENGLISH 12
Technical data
Dimensions
Width (mm) 580
Height (mm) 40
Length (mm) 510
Voltage (V) 220 - 240
The technical information are situated in the
rating plate on the bottom side of the appliance.
Installation
Afterunpackingthehob,makesurethatit
has not been damaged during transport. In
the event of problems, contact the dealer or
your nearest After-sales Service.
Technical information for the installer
- This product can be embedded in a
worktop20to50mmthick.
- If there is no oven beneath the hob,
insert a separator panel that has a
surface at least equal to the opening
intheworksurface.Thispanelmustbe
positioned in no case less than 20 mm
from the bottom of the hob.
- Beforeinstallation,makesurethat:
- the local gas delivery conditions (nature
andpressure)arecompatiblewiththe
settings of the hob (see the rating plate
and injector table);
- the outer surfaces of the furniture or
appliances adjacent to the hob are heat
resistant according to local regulations;
- This appliance is not connected to a
fume exhaust device. It shall be installed
inaccordancewithcurrentinstallation
regulations.Particularattentionshall
be given to the relevant requirement
regarding ventilation.
- Combustion products are discharged
outdoorsthroughspecichoodsorwall
and/orwindowmountedelectricalfans.
Gas connection
This operation must be performed by a
qualiedtechnician.
Thegassupplysystemmustcomplywith
local regulations to the relavant gas
standard.
- Youcanndspeciclocalregulations
for some countries in the paragraph
“ReferencetoLocalRegulations”.Ifno
information concerning your Country is
given,pleaseaskdetailstoaqualied
technician.
- The connection of the hob to the gas
pipenetworkorgascylindermustbe

IKEA LIVSLAGA Specifications

General

Brand	IKEA
Model	LIVSLAGA
Category	Hob
Language	English