Problem Possible cause Remedy
and a number come on.
There is an error in the hob. Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an authorised installer.
comes on.
There is an error in the hob
because a pot boiled dry. Au‐
tomatic Switch O and the
overheating protection for
the zones operate.
Switch o the hob. Remove
the hot cookware. After ap‐
proximately 30 seconds, acti‐
vate the zone again. If the
cookware was the problem,
the error message goes out.
Residual heat indicator can
stay on. Let the cookware be‐
come suciently cool. Check
if your cookware is compati‐
ble with the hob.
Refer to "Cookware guid‐
ance".
If there is a fault, try to resolve it by following
the troubleshooting guidelines. If the
problem cannot be resolved, contact your
IKEA store or the After Sales Service. You can
nd a full list of IKEA appointed contacts at
the end of this user manual.
If you operated the appliance
wrongly, or the installation was
not carried out by an authorised
installer, the visit from the After
Sales Service technician or dealer
may not take place free of charge,
even during the warranty period.
Technical data
Rating Plate
Model
00000000
PNC 000 000 000 00 S No .................... 220V-240V AC 50-60 Hz
Typ 60 GAD DC AU 3.0kW
000.000.00
Made in ...
21552
MODEL
© Inter IKEA Systems B.V. 2019
PI-000000-0
IKEA of Sweden AB
SE - 343 81 Älmhult
The graphic above serves to represent the
rating plate of the appliance. The actual
rating plate is located on the bottom of the
casing. The serial number is specic to each
product.
Dear Customer, keep the additional rating
plate with the user manual. This will allow us
to assist you better by identifying precisely
your hob, in case you need our assistance in
the future. Thank you for your help!
ENGLISH 19
To Next Page
Loading...
Need help?
General
