InFocus IN24 User Manual

4
Turn on projector and source
Connect the power cord to the projector
and to an electrical outlet
The green power light on the projector will turn on.
Turn on the projector
Press power (on the projector or remote).
The power light will start blinking.
Wait for the lamp to warm up
After a few seconds, the power light will stop blinking and stay
on. It can take a minute for the lamp to reach ful
l brightness.
5-10 sec.
1
2
3
Turn on computer or other source
4
Change source if needed
If needed, press source (on the projector or remote) to view the
source. You may have to press it more than once.
5
Warning: Do not look directly into the lens
when the projector is turned on.
You may need to press a specific key combination to activate
your laptop’s external video port. On most laptops, hold down
the Fn key while pressing a key labeled CRT/LCD, LCD/VGA,
a monitor icon , or similar. Key combos for popular models:
Apple F7
Dell Fn+F8
Fujitsu Fn+F10
Gateway Fn+F3 or Fn+F4
HP/Compaq Fn+F4 or Fn+F5
Sony Fn+F7
IBM ThinkPad Fn+F7
Toshiba Fn+F5
Complete laptop activation chart at www.infocus.com/support
Important: If there is still no video, restart your
computer (first make sure it’s con
nected to the
projector and the projector is turned on).
i

InFocus IN24 Specifications

General

Matrix size	0.55 \
Number of colors	16.78 million colors
Native aspect ratio	4:3
Projection distance	- m
Vertical scan range	50 - 85 Hz
Horizontal scan range	15.85 - 85 kHz
Projection technology	DLP
Supported aspect ratios	4:3, 16:9
Contrast ratio (typical)	2000:1
Screen size compatibility	33.6 - 248.4 \
Projector native resolution	SVGA (800x600)
Keystone correction, vertical	25 - 30 °
Projector brightness (economic mode)	1360 ANSI lumens
Lamp type	SHP
Lamp power	200 W
Light source type	Lamp
Lamp power (economic mode)	160 W
Service life of light source	3000 h
3D	-
Full HD	No
Supported video modes	1035i, 1080i, 480i, 480p, 576i, 576p, 720p
Analog signal format system	NTSC, PAL, SECAM
Noise level	35 dB
Plug and Play	Yes
Power source	AC
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	- W
Power consumption (typical)	250 W
Operating temperature (T-T)	10 - 40 °C
Focal length range	- mm
RS-232 ports	0
Maximum analog resolution	1024 x 768 pixels
RMS rated power	1 W
Number of built-in speakers	1
USB connector type	USB Type-B
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Placement	Desktop, Ceiling
Product type	Standard throw projector
Product color	Black, Silver

Weight and Dimensions

Weight	2700 g