21
Connecting an External Speaker
To connect one or two external speakers, plug the speaker cable
into the (audio out) connector on the projector.
NOTE: The external speakers
must be amplified.
F
IGURE
20
Connecting an external speaker
Powering up the Projector and Adjusting the Image
NOTE: Always use the power cord
that shipped with the projector.
1 Remove the lens cap.
2 Plug the power cord into the front of the projector, then plug it
into your electrical outlet. A surge-protected power strip is
recommended if power surges are common in your area.
3 Turn on the projector.
CAUTION: If the lamp LED
remains solidly lit after the LitePro
has powered on, the lamp needs
to be replaced. Refer to “Replacing
the Projection Lamp” on page 41
for more information.
•
The In Focus startup screen displays and the Power LED
lights (Figure 25 on page 27).
4 If you connected a video player, turn it on.
•
Press the
video
button on the keypad to display the image
from your video player. Press
computer
to return to your
computer’s image. (You can select a default source to deter-
mine which source the projector examines first during
power-up for active video; see “Default Source” on
page 32.)
•
Use the
volume
buttons to adjust the volume.
Downloaded From projector-manual.com Boxlight Manuals
To Next Page
Loading...
Need help?
General