INFOSEC UPS SYSTEM - 15, rue du Moulin - 44880 Sautron - FRANCE - www.infosec-ups.com
Hot Line – Tel + 33 (0)2 40 76 15 82 - Fax + 33 (0)240 94 29 51 - hotline@infosec.fr – 06 17 AA 59 205 05
Step 2 - UPS output connection
For socket-type outputs, there are two kinds of outputs: programmable outlets and general
outlets. Please connect non-critical devices to the programmable outlets and critical devices
to the general outlets. During power failure, you may extend the backup time to critical
devices by setting shorter backup time for non-critical devices.
Step 3 - Communication connection
Communication ports:
To allow unattended UPS shutdown/start-up and status monitoring, connect the
communication cable one end to the USB/RS-232 port and the other to the communication
port of your PC. Once the software Infopower installed on your computer, you can schedule
UPS shutdown/start-up and monitor UPS status through PC.
The UPS is equipped with intelligent slot perfect for either SNMP or AS400 card. When
installing either SNMP or AS400 card in the UPS, it will provide advanced communication
and monitoring options.
PS: USB port and RS-232 port can’t work at the same time.
Step 4 - Network connection
Network/Fax/Phone surge port:
Connect the modem/phone/fax line into surge-protected “IN” outlet on the back panel of the
UPS unit. Connect from “OUT” outlet to the equipment with another modem/fax/phone line
cable.
Step 5 - Disable and enable EPO function
This UPS is equipped with EPO function. By default, the UPS is delivered from factory with
Pin 1 and pin 2 closed (a metal plate is connected to Pin 1 and Pin2) for UPS normal
operation. To activate EPO function, remove two screws on EPO port and green connector
will be removed.
Note: The EPO function logic can be set up via LCD setting. Please refer to program 16 in
UPS setting for the details.
It’s in closed status
for UPS normal
operation as
default.
To activate EPO
function, remove
these two screws.
To Next Page
Loading...
Need help?
General
