4.6. Paper roll
4.6.1.
Mains characteristics of INGENICO paper roll
Depending on IWL model two paper roll can be used:
R40 paper roll Characteristics Precisions
Colour White
Width 58 mm
Diameter 40 mm
Length About 18 metres
• The thermal paper can be deteriorated by poor storage conditions, so we
recommend you to avoid :
– storage in hot wet places (near air-conditioner, humidity higher than 85%)
– exposure to sunlight or ultraviolet for long periods
– contact with organic solvents (solvent type adhesive)
– direct contact with materials containing plasticizers (PVC transparent
folders or envelopes)
– direct contact with «diazo» papers
– direct contact with water
– Rubbing or pressing the paper too strongly
WARNING
For best product performance, only use heat sensitized paper approved by Ingenico.
WARNING
Switch off the terminal prior to installing a paper roll.
Use only paper approved by Ingenico.
The use of non approved paper is likely to damage the printer of your terminal.
USER GUIDE
• 20/28 Copyright © 2012 Ingenico
R11 900017771 000 02 All rights reserved
4.6.2.
Installing paper roll
• Open the paper compartment by lifting the catch located at the rear of the terminal and
pull the cover to the rear of the terminal.
• Insert the paper roll in the compartment following the directions shown on the below
picture
• Pull the paper up to the top of the terminal
• Maintain the paper and close the lid
• Press simultaneously on both upper corners of the paper flap, as shown by arrows on
picture, until it clips into position
ADVICE
If you insert a new R40 paper roll, tear off the first length (one complete turn to avoid
printing on adhesive tape footprint).
To Next Page
Loading...
Need help?
General
