Inovance MDKE9 Series User Manual

4 Function and Application
- 21 -
4
4.2.2 Add the Parameter to the"Shortcut" Interface
In parameter list, move the cursor to the parameter to be added and hold down the and for 1.5s.
you can add 20 parameters to the shortcut interface and a prompt will appear to indicate whether the
parameter is added successfully or not.
The parameters in the shortcut interface are in chronological order based on the time when they are added.
Take adding F1-00 to the shortcut interface as the example. The adding steps are as follows:
Figure 4-7 Example of adding parameters to the shortcut interface
Inverter
Select18: 00: 02
Loc
Stop
Back
Select18: 00: 02
Loc
Back
• F1-00 Motor type selection
0: Common asynchronous motor
F1-01 Rated motor power
11.0KW
F1-02 Rated motor voltage
380V
Inverter Stop
• F1-00 Motor type selection
0：普通异步电机
F1-01 电机额定功率
11.0KW
F1-02 电机额定电压
380V
Add Shortcut OK!
On the shortcut interface, move the cursor to the function code to be deleted, and press and at the
same time to delete the function code from the short cut interface
4.3 Status Monitoring
On status monitoring interface, you can view the current status of the fault equipment, the modified
parameters, the shortcut, and the history fault.
Table 4-4 Status monitoring description
Task Action
Check the current faults of all
equipment
Open “menu”-”status monitoring”-”fault status”
View the modied parameters Open “menu”-”status monitoring”-”modied parameter”.
View the history fault information.
Open “menu”-”status monitoring”-”fault status”.
Delete history faults
Press after logging into the system.
An interface pops up with selection “Delete history faults?” Press
again to complete the procedure.
4.3.1 Fault Viewing
In the fault interface, you can view all current faults of the device. Including the fault occurring time and
detailed fault description.
4.3.2 Modied Parameters
Parameters that are different from the default values are listed in this page, and the order is determined by
parameter numbers. Parameter scanning time may vary depending on the specic device, wait patiently
based on the prompts.

Inovance MDKE9 Series Specifications

General

Brand	Inovance
Model	MDKE9 Series
Category	Control Panel
Language	English