www.insigniaproducts.com
36
Cleaning and maintenance
Using the oven vent
• The oven vent is located above the right-rear surface element.
• The vent area can become hot during oven use.
• Steam coming out of the vent is normal.
• The vent is important for correct air circulation. Never block this vent.
Cleaning the control panel
1 Lock the oven controls. See Locking oven controls on page 34.
2 Clean spatters with a damp cloth or glass cleaner. You can use warm, soapy water to clean heavily soiled areas.
3 When cleaning is done, unlock the oven controls.
Cleaning painted parts and decorative trim
• For general cleaning, use a cloth with hot, soapy water, then dry with a clean, dry, soft cloth.
• For more difficult residue and built-up grease, apply a liquid detergent directly onto the area and leave for 30 to 60
minutes. Wipe with a damp cloth and dry with a clean, dry, soft cloth.
Cleaning stainless steel surfaces
1 Place a small amount of a stainless steel cleaner designed for use with appliances on a damp cloth or damp paper
towel.
2 Clean a small area, rubbing with the grain of the stainless steel, if applicable.
3 Dry and buff with a clean, dry paper towel or soft cloth.
4 Repeat as necessary.
WARNING:
• Always make sure that the controls are off and all surfaces are cool before removing or cleaning any of the range parts. This will
prevent you from getting burned.
• If your range is pulled out from the wall for any reason, make sure that the anti-tip device is reengaged after your range has been
pushed back into place. Failure to take this precaution could result in your range tipping and personal injury.
CAUTION:
• Never use steel wool or abrasive cleansers.
• Protect the surface from sharp objects.
These items can damage the surface.
CAUTION: Do not use a steel-wool pad or abrasive cleaners on stainless steel surfaces. Abrasive pads and cleaners will scratch the
surface and damage the finish.
CAUTION: Do not use a steel-wool pad or abrasive cleaners on stainless steel surfaces. Abrasive pads and cleaners will scratch the
surface and damage the finish.
Note: To prevent any discolorations or grease stains, we recommend that you clean and remove any spills, spots, and grease from your
range after each use.
Note: If you previously used a mineral oil-based stainless steel appliance cleaner, wash the surface with dish washing liquid and water
before using the stainless steel cleaner.
To Next Page
Loading...
Need help?
General
