19
2-4 Install Memory
This motherboard provides four 240-pin DDR2 DUAL INLINE MEMORY MODULES
(DIMM) socket for DDR2 memory expansion available from minimum memory volume of
128MB to maximum memory volume of 4 GB DDR SDRAM and two 240-pin DDR DIMM
socket for DDR3 memory expansion available from minimum memory volume of 128MB
to maximum memory volume of 4 GB .
Valid Memory Configurations
Bank 240-Pin DIMM PCS Total Memory
Bank 0, 1 (DIMM1)
DDR2 667 /DDR2 800 X1
128MB∼2GB
Bank 2, 3 (DIMM2)
DDR2 667 /DDR2 800 X1
128MB∼2GB
Total System Memory (Max. 4GB) 4
128MB∼4GB
Recommend DIMM Module Combination
1. One DIMM Module ----Plug in DIMM1
2. Two DIMM Modules---Plug in DIMM1&DIMM2.
For Dual channel Limited!
1. Dual channel function only supports when 2 DIMM Modules plug in two slots of the same
colure.
2. DIMM Modules must be the same type, same size, and same frequency for dual channel
function.
Install DDR SDRAM modules to your motherboard is not difficult, you can refer to figure
below to see how to install a 240-Pin DDR2 667/DDR2 800 SDRAM module.
DIMM2 (BANK2+ BANK3)
DIMM1 (BANK0+ BANK1)
NOTED!
When you install DIMM module fully into the DIMM socket, the eject tab
should be locked firmly and fit into its indention on both sides.
WARNING!
This motherboard only supports DDR2 667/800 or higher frequency-
compliant DDR2 Modules.
To Next Page
Loading...
Need help?
General
