Installing and Replacing Desktop Board Components
37
Connecting Hardware Control Cables
See Figure 11 for fan and chassis intrusion header locations. Connect the processor’s fan heatsink
cable to the processor fan header on the board (see Figure 11, C). Connect chassis fan cables to the
board fan headers (see Figure 11, B and E). Connect the chassis intrusion cable to the respective
header on the board (see Figure 11, F).
Connecting Power Cables
CAUTION
Failure to use an ATX12V power supply, or not connecting the 12 V processor core voltage power
supply connector to the desktop board may result in damage to the desktop board and/or power
supply.
Figure 11 shows the location of the power connectors.
1. Observe the precautions in “Before You Begin” on page 21.
2. Connect the 12 V processor core voltage power supply cable to the 2x2 connector
(see Figure 11, A).
3. Connect the main power supply cable to the 2x10 connector (see Figure 11, D).
To Next Page
Loading...
Need help?
General
