Intel D845PEBT2 Quick Reference

6 Intel Desktop Board D845PEBT2 Quick Reference
✏
NOTES
Desktop Board D845PEBT2 has been designed to support DIMMs based
on 512 Mbit technology up to 2 GB, but this technology has not been
validated on this board.
All memory components and DIMMs used with the desktop board must
comply with the PC SDRAM specifications. These include the PC
SDRAM Specification (memory component specific), the PC Unbuffered
DIMM Specification. To view or download these specifications, refer to
this Intel World Wide Web site:
http://www.intel.com/technology/memory/pcsdram/
For information about vendors that support these memory requirements,
refer to the Desktop Board D845PEBT2 link on this Intel World Wide
Web site:
http://support.intel.com/support/motherboards/desktop/
Installation Steps
1 Installing the I/O Shield
The board comes with an I/O shield that is used to block radio frequency
transmissions, necessary to pass emissions (EMI) certification testing, protect
internal components from dust and foreign objects, and promote correct airflow
within the chassis.
Install the I/O shield before installing the board in the chassis. Place the shield
inside the chassis as shown in the following figure. Press the shield into place so
that it fits tightly and securely. If the shield doesn’t fit, obtain a properly sized
shield from the chassis supplier.
OM14811

Intel D845PEBT2 Specifications

General

Brand	Intel
Model	D845PEBT2
Category	Motherboard
Language	English