109
SAVE THESE INSTRUCTIONS
Page 12
(109) MODEL 633 FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 09/26/2008
English
PPOOOOLL MMAAIINNTTEENNAANNCCEE
POOL CARE AND CHEMICALS (continued)
CAUTION
Concentrated chlorine solutions may damage the pool liner. Always
follow the chemical manufacturer’s directions, and the health and hazard
warnings.
LONG TERM STORAGE
1. Before emptying your pool for long term storage, or relocation, be sure the
water is directed towards an acceptable drain water receptacle away from the
house. Check local regulations for specific directions regarding disposal of
swimming pool water.
2. Disconnect power cord from electrical outlet.
3. After pool is empty of all water disconnect all hoses from pump and plunger
valves and remove strainers from pool wall.
4. Drain all water from inside filter pump.
5. Leave filter pump pieces & hoses outside to thoroughly air dry.
6. Twist the plunger collar counter-clockwise removing the water flow control
mechanism from the plunger housing.
7. Coat the following O-rings and washers with petroleum jelly for long term
storage:
• Air release valve & sediment O-rings (3).
• Filter housing cover O-ring (5).
• Pump hose O-rings (10).
• Strainer valve assembly step washers (11).
• Flat strainer rubber washers (13).
8. Discard "OLD" used filter cartridge. Have 1-2 new cartridges available for next
season’s use.
9. Place all dry pieces in the original packaging for storage or place in an airtight
plastic bag.
10. Store the unit and accessories in a dry, temperature controlled, between 32
degrees Fahrenheit (0 degrees Celsius) and 104 degrees Fahrenheit (40
degrees Celsius) storage location.
To Next Page
Loading...
Need help?
General
