Intex 633 User Manual

109
SAVE THESE INSTRUCTIONS
Page 13
(109) MODEL 633 FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 09/26/2008
TROUBLESHOOTING GUIDE
TTRROOUUBBLLEESSHHOOOOTTIINNGG GGUUIIDDEE
IMPORTANT
If you continue to experience difficulty, please contact our Consumer
Service Department for assistance. See back cover for contact information.
English
• Filter cord must be plugged into a 3 wire
outlet that is protected by a Class A
Ground Fault Circuit Interrupter.
• Reset circuit breaker. If circuit breaker trips
repeatedly, your electrical system may
have a defect. Turn off circuit breaker and
call an electrician to correct the problem.
• Motor too hot and overload protection shut
motor off. Let motor cool down.
• Adjust chlorine and pH level. Consult your
local swimming pool supply stores.
• Clean or replace cartridge.
• Check for holes in cartridge. Replace if
damaged.
• Operate filter for longer periods.
• Clean strainer screen at pool wall inlet.
• Look for obstructions in intake hose or
discharge hose inside pool wall.
• Tighten hose nuts, check hoses for
damage, check pool water level.
• Clean cartridge more often.
• Clean inside plunger valve.
• Pull valve handle to full upright position.
• Install the nozzle at the upper position of
pool inlet, and the strainer at the lower
position of pool outlet.
• Fill pool to correct water level.
• Clean strainer screens at pool inlet.
• Tighten hose nuts, check hose for damage.
• Check & clear any sticks or leaves in
intake to pump.
• Turn & pull valve handle to full upright
position.
• Remove cover & check for O-ring.
• Tighten cover (Manually).
• Replace or clean cartridge.
• Tighten/reinstall hose nut.
• Open air release valve, wait until water
starts to flow out of the air release valve,
close air release valve.
• Lower position of pool outlet connect to
filter pump water inlet, upper position of
pool inlet connect to filter pump water
outlet.
FILTER MOTOR
FAILS TO START
FILTER DOESN’T
CLEAN POOL
FILTER DOESN’T
PUMP WATER OR
FLOW IS VERY
SLOW
PUMP DOESN’T
WORK
TOP COVER
LEAKING
HOSE LEAKING
AIR LOCK
• Not plugged in.
• Fuse box needs checking.
• GFCI circuit breaker
tripped.
• Improper chlorine or pH
levels.
• Filter cartridge dirty.
• Cartridge damaged.
• Excessively dirty pool.
• Strainer screen restricting
flow.
• Inlet/discharge clogged.
• Air leak on intake line.
• Scale or buildup on
cartridge.
• Excessively dirty pool.
• Filter cartridge dirty.
• Nozzle and strainer
connection reversed.
• Low water level.
• Strainer screen plugged up.
• Air leak on intake hose.
• Faulty motor or impeller
jammed.
• Air lock inside cartridge
chamber.
• O-ring missing.
• Cover not tight.
• Filter cartridge dirty.
• Hose nuts.
• Pump housing and inlet
hose air trapped.
• Inlet and outlet hoses
connection reversed.
TROUBLE CHECK POSSIBLE SOLUTIONS

Intex 633 Specifications

General

Brand	Intex
Model	633
Category	Swimming Pool Pump
Language	English