100
IO
SAVE THESE INSTRUCTIONS
Page 11
(100IO) AUTO CLEANER ENGLISH 7.5” X 10.3” PANTONE 295U 08/05/2008
TROUBLESHOOTING GUIDE
TTRROOUUBBLLEESSHHOOOOTTIINNGG GGUUIIDDEE
IMPORTANT
If you continue to experience difficulty, please contact our
Consumer Service Department for assistance. See back cover for
contact information.
Q. What should I do if Auto Cleaner doesn’t move or movement is very
slow?
A. 1. Pull the cleaner’s hose and lift auto cleaner off from the wrinkles.
2. Check the circulation line:
i. Ensure the filter pump is turned on.
ii. Ensure the plunger valves are opened.
iii. Clean or replace cartridge.
Q. What should I do if Auto Cleaner lifts off from the pool floor?
A. Release air from the auto cleaner by following the “Owner’s Manual”.
Q. What is the easiest way to carry the Auto Cleaner out from the pool
after used?
A. Release the water inside the auto cleaner by following the steps below:
1. Make sure the filter pump is turned off, and disconnect the power
cord from the electrical outlet.
2. Pull the cleaner’s hose slowly and lift the auto cleaner up just right
below the water surface.
3. Hold the hose with one hand, and lift the auto cleaner up slowly
with an angle (either head or tail up) by carrying the cleaner bottom
with another hand.
4. After the water has been fully released from the auto cleaner, carry
the auto cleaner out with both hands. DO NOT lift the hose or
bumper which could be damaged.
English
To Next Page
Loading...
Need help?
General
