(110GS) MODEL 634RC FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/13/2022
110
GS
SAVE THESE INSTRUCTIONS
English
Page 13
POOL CARE AND CHEMICALS
• All pools require care to keep the water clear and hygienically clean. With proper chemical
control, your filter will help attain this objective. Consult your pool supply dealer for
instructions regarding the proper use of chlorine, algaecide and other chemical agents
required for sparkling clear water.
• Keep pool chemicals away from children.
• Do not replenish chemicals in pool while pool is occupied. Skin or eye irritations could
occur.
• Daily pH checking and chemical treatment of the water is very important and can not be
overemphasized. Chlorine, algaecide and maintenance of proper pH levels are required
when filling the pool as well as during the season. Consult your local swimming pool supply
store for instructions.
• The season’s first filling of the pool may have brackish water requiring extra water
additives and extra filter changes. Do not allow swimming in pool until the pH level is
balanced. Consult your local swimming pool supply store for instructions.
• Keep spare filter cartridges on hand. Replace cartridges every two weeks.
• Chlorinated water may damage lawns, gardens or shrubbery as children play in the pool
and splash water outside the pool. Lawn areas underneath the pool liner will be destroyed.
Note that some types of grass may grow through the liner.
• Filter run time depends on pool size, weather and usage level. Experiment with various run
times so as to produce clean clear water.
• European standard EN16713-3 lists some additional pool water quality and water treatment
information that can be found at www.intexcorp.com/support.
CAUTION
Concentrated chlorine solutions may damage the pool liner. Always follow the
chemical manufacturer’s directions, and the health and hazard warnings.
1
. Before emptying your pool for long term storage, or relocation, be sure the water is directed
towards an acceptable drain water receptacle away from the house. Check local regulations
for specific directions regarding disposal of swimming pool water.
2.
Disconnect power cord from electrical outlet.
3.
Now, drain the pool.
4.
When the pool is empty, disconnect all hoses from pump and plunger valves and remove
the strainers from the pool wall.
5.
Drain all water from the filter pump.
6.
Leave filter pump pieces & hoses outside to thoroughly air dry.
7.
Remove both plunger valves from the connectors
(14 & 19)
. Be careful not to lose the step
rubber washer
(22)
.
8.
Coat the following O-rings and washers with petroleum jelly for long term storage:
• Air release valve & sediment O-rings
(3 & 11)
.
• Filter housing cover O-ring
(5)
.
• Pump hose O-rings
(21).
• Strainer valve assembly step washers
(22)
.
• Flat strainer rubber washers
(13)
.
9.
Discard the used filter cartridge. Put aside 1 or 2 new cartridges for next season’s use.
10.
It is best to place all dry pieces in the original packaging for storage or place them in an
airtight plastic bag.
11.
Store the unit and accessories in a dry place. The storage’s temperature should be
controlled, between 32 degrees Fahrenheit (0 degrees Celsius) and 104 degrees Fahrenheit
(40 degrees Celsius) storage location.
LONG TERM STORAGE & WINTERIZATION
To Next Page
Loading...
Need help?
General
