Ispring RCC Series User Manual

www.123filter.com | +1 (678) 261-7611 | support@123filter.com Page 6
Installation
Before you start the installation
• It is highly recommended that you watch the video "iSpring RCC Series RO System with
Deionized Filter DIY Installation | Step by Step" on YouTube.
• Choose a suitable location for the system. Again, it must be placed on a flat surface, and make
sure this system is to be installed on INDOOR cold-water supply ONLY.
• Check the packing list to confirm that all accessories are included in the package. Contact
iSpring customer serv
ice if any components are missing.
• Required tools:
• Recommended tools:
 Variable speed drill with two bits: 1/4" (for drilling a hole on PVC drain pipe)
 5/8", 9/16" open-end wrench, or adjustable wrench, pliers
• Quick connect instruction:
It is highly recommended that you watch the video "How to Connect and Disconnect Quick
Connect Fittings | DIY Installation" on YouTube.
Cut the tubing end squarely using a utility knife or scissors. Insert the tubing into the quick
connect fitting for at least 1
/2''. You will need to wiggle the tube and apply additional pressure
to create a seal.
HOW TO CONNECT
① ② ③
① ② ③
HOW TO DISCONNECT
PUSH IN
INSERT
REMOVE
PRESS
PULL
DISCONNECT
At least 1/2" in
LOCK

Ispring RCC Series Specifications

General

Brand	Ispring
Model	RCC Series
Category	Water Filtration Systems
Language	English