www.123filter.com | (678) 261-7611 | support@123filter.com Page 12
Using the system
▪ System Startup
a. To start the system, plug it in, turn on the feed water adapter, then turn on the faucet. Vibrations
can be expected as the pump starts.
b. Turn on the faucet and let it run for at least 30 minutes to rinse the system. This should be done
each time the PPC filter is replaced. Refer to the below "Display and Operating Area" section for
more information about manually flush the system after the membrane has been replaced.
c. Carefully check all fittings for a secure connection. Use a damp paper towel to wipe clean and
verify that no connection is leaking.
d. Once the rinsing is completed, and no leaks is presented, the system is ready for use.
▪ Display and Operating Area
The display/Operating area is located in the lower front side of the system that is a made with a
combination of 3 indicating lights and 2 buttons.
To manually Flush the system:
Press "select/flush" for 5 seconds. The machine will start the flush process that lasts for 30 seconds.
During the process, the red light will flash.
"On" Light:
The white light flashes when the system is running and filtered water is being dispensed. This light
remains on when the system is in standby mode.
To Next Page
Loading...
Need help?
General
