Page 13 www.123filter.com | (678) 261-7611 | support@123filter.com
Reset filter:
Filter life indicating lights remain to be white and started to blink in white when the corresponded
filter life has less than 10% remaining, then turn red when the filter needs to be replaced ASAP.
Filter life indicator must be reset each time the filters is replaced.
To replace the filter,
1. Shut off the water supply and turn on the faucet to drain the remaining water in the system.
2. Unplug the power adapter.
3. Press the button on the filter to release filter lock. Remove the package of the new filter, then
insert the filter into the system firmly, make sure the filter is locked in place.
4. After replacing the filter, press and hold "reset" button for 3 seconds to enter the reset mode, by
default the indicator light of "PPC" filter will be flashing red with one beep.
5. Short press "select/flush" and select the RO filter indicator light and select the filter which needs
to be reset. Repeat the process for a different filter light if needed.
▪ Routine Maintenance
Actual filter replacement cycle varies depend on source water quality actual usage of the system
(family size, usage frequency etc.). Time between each filter replacement should not exceed the
maximum suggested data. Failure to replace the filters on time will void the warranty and may
cause damage/leaking to the system that leads to further damage to the property where the system is
installed.
To Next Page
Loading...
Need help?
General
