Isuzu AU-4LE1T User Manual

14
EMISSION CONTROL LABEL: ENGINE LABEL (EPA, EC COMBIND TYPE)
Emission control label is attached at the center of injection pump cover located at the right side of cylinder body, or on the
cylinder head cover.
The location of emission control label attached on the engine may vary depending on the engine specification.
The following is the sample of a label required for engine emission control information, along with location.
4LE1T
ENGINE FAMILY
ENGINE CODE
MODEL
POWER CATEGORY
ADVERTISED POWER (SAE NET)
: XX.X kW / XXXX RPM
FUEL RATE : XX mm
/st.
3
VALVE LASH (COLD)
INL/EXH : XX / XX mm.
INITIAL INJECTION TIMING
CURB IDLE : XXX RPM
EMISSION CONTROL INFORMATION
ISUZU MOTORS LTD. MADE IN JAPAN
THIS ENGINE COMPLIES WITH U.S. EPA REGULATIONS FOR XX MY
NONROAD DIESEL ENGINES AND CALIFORNIA REGULATIONS FOR XX
MY OFF-ROAD DIESEL ENGINES.
EXHAUST EMISSION CONTROL SYSTEM
SEE SERVICE MANUAL FOR
MODEL SPECIFICATIONS.
ENGINE FAMILY : XXXXXXXXXX
ENGINE TYPE : XXXXXXXXXX
THIS ENGINE IS CONFORMED 97/68/EC DIRECTIVE.
ENGINE I.D.NUMBER :
XXXX-XXXX
TYPE APPROVAL NUMBER : XXXXXXXXXXXXXXXXXX
XXXXXX
: XX-XXXXX
: XXXXXXXXX-XX
: XXXXXXX.XXXX
: XX < kW < XX
XXXXXXXXXXXXXXXXXX
: XXXXXXXXXXXXXXXXXX
LOW SULFUR FUEL OR ULTRA LOW
SULFUR FUEL ONLY
XXXXXXXXXX XXXXXXXXXX
: XXX BTDC
IMLE0097

Isuzu AU-4LE1T Specifications

General

Brand	Isuzu
Model	AU-4LE1T
Category	Engine
Language	English