68
4) Tighten the plug when the coolant spills over from the air bleeder plug.
(Turbocharged engine only)
CAUTION:
1. Take care to prevent the spilt coolant from getting the
exhaust system parts wet.
2. If you spill coolant, wipe it properly, or this could lead to a
fire.
Torque (Air bleeder plug) : 24.5 to 30.5 Nm (2.5 to 3.1 kgm)
5) Add coolant in the radiator and reservoir tank.
6) With the coolant poured, operate the engine about five minutes at a
low idle speed, then the air contained in the coolant circuit is bled.
The coolant level will drop.
Stop the engine to replenish with the coolant.
(4) Cleaning outside of Radiator
Mud or dried grass caught between radiator fins will block the air flow,
resulting in lower cooling efficiency.
Clean the radiator fins with steam or compressed water.
For the cleaning interval, refer to the instruction manual prepared by
the equipment manufacturer.
If the fins are stuffed, however, clean them at any time. Further, if the
fins are deformed, repair or replace them.
To Next Page
Loading...
Need help?
General
