EasyManuals Logo

Isuzu AU-4LE1T User Manual

Isuzu AU-4LE1T
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #67 background imageLoading...
Page #67 background image
62
CAUTION:
1. Prevent dust particles from entering through filler port at
replenishment. Be careful, entry of dust particles may
cause engine damage or accident.
2. Replenishment of oil above "Max" level or below "Min" level
may cause engine damage or accident. Drain oil to the
"Max" level if the oil level is above "Max" level. Also,
replenish oil to the "Max" level if the oil level is below "Min"
level.
(2) Check after Oil and Filter Changes
The remote-type oil filter is used so that it takes time to pressure-feed
oil to each part of engine after oil filter is changed. Idle approx. 30
seconds at the first start-up after oil filter is changed. Do not perform
sudden loading or rapid acceleration. In addition, the time to
pressure-feed oil can be shortened by filling engine oil into oil filter.
Oil leakage check
Idle the engine to raise the oil pressure, then check for oil leakage.
Oil level recheck
Stop the engine and keep it stationary about twenty minutes.
Use the dipstick to recheck the oil level.
Replenish with engine oil, if necessary, to the specified level.
CAUTION:
When the engine is started, the oil level will slightly drop from
the initial level as the oil fully comes into the entire oil circuit.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Isuzu AU-4LE1T and is the answer not in the manual?

Isuzu AU-4LE1T Specifications

General IconGeneral
BrandIsuzu
ModelAU-4LE1T
CategoryEngine
LanguageEnglish

Related product manuals