To Next Page

To Previous Page

Voltage Control Commands

Return parameters:

<NR2>

VOLT:PROTection {<volts>|MINimum|MAXimum}

This order is used to set the upper limit of over voltage protection point. If the

output voltage value is higher than the upper limit of OVP, then we can assume

that internal parts has been shorted. Query state register ”OV” bit has been set.

When power supply is protected, then we can through order VOLT:PROT:CLE

to clear the OVP state.

Order syntax:

[SOURce:]VOLTage:PROTection[:LEVel] <NRf>

Parameters:

MIN to MAX

Unit:

Query syntax:

VOLT:PROT? { MINimum|MAXimum}

Return parameters:

<NR2>

VOLT:PROTection:STATe {0|1|OFF|ON}

This order is used to open or close OVP function i.e. to set the state of OVP.

Order syntax:

[SOURce:]VOLTage:PROTection:STATe

Parameters:

0|1|OFF|ON

Query syntax:

VOLTage:PROTection:STATe?

Return parameters:

0|1

ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT6942A Programming Guide

Other manuals for ITech IT6942A