ITech IT8625 Programming Guide

Load Commands
Copyright © Itech Electronic Co., Ltd. 33
Returned value:
NR3
WAVE:TRIGger:CURRent[:LEVel]
This command is used to set the current trigger level.
Command syntax:
WAVE:TRIGger:CURRent[:LEVel]
Parameter
<NRf>
Unit
A
Query Syntax:
WAVE:TRIGger:CURRent[:LEVel]?
Returned value:
NR3
WAVE:TRIGger:SOURce
This command can set or read the device taking which kind waveform as trigger
source.
Command syntax:
WAVE:TRIGger:SOURce <VOLTage|CURRent>
Parameter:
VOLTage|CURRent
Query Syntax:
WAVE:TRIGger:SOURce?
Returned value:
VOLTage|CURRent
WAVE:TRIGger:SLOPe
This command is used to set trigger slope when takes waveform as trigger
source.
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com

ITech IT8625 Specifications

General

Brand	ITech
Model	IT8625
Category	Test Equipment
Language	English