Ivation IVACDEH15P User Manual

5
USING YOUR DEHUMIDIFIER
• CAUTION: Do not place the dehumidifier in a broom cupboard,
boiler room, or similar small, unventilated rooms. Avoid placing
the dehumidifier in small, confined areas; in close proximity to a
radiator; or close to a similar heat source, such as tumble dryers
and ovens, to prevent the dehumidifier from overheating.
• Do not use this dehumidifier in a dusty or industrial environment,
where particles can get into the unit. This will cause a malfunction and
void your warranty.
• The water bucket must be properly installed and emptied in order
for the dehumidifier to function. If the tank is full or not in place, the icon will start blinking and the
unit will stop running.
• Do not remove the bucket while the unit is in operation. If the bucket needs to be emptied, please make
sure you shut o the unit first. You should not remove it while the unit is running to avoid risk of electrical
shock, water leakage, or other safety hazards.
• All successful button presses on the control panel will be indicated with an auditory “beep” response
as confirmation.
• Do not insert small objects into the unit. This will damage it, cause a hazard, and void your warranty.
• When the power cable is connected, the indicator light above the power button will be lit and the
dehumidifier will beep to confirm it has been connected to a power source.
Powering On & O
1. Plug the power cable into the appropriate electrical outlet.
2. Press the on/o button to turn the unit on. The LCD panel will light up.
3. If the dehumidifier has previously been properly switched o, and you are turning it back on again, it will
resume operating with your previously applied settings for the mode, humidity, and backlight. The timer
setting will be the only one reset.
4. If the power is being restored after a power failure, all settings will be restored, including the timer.
5. To power down the dehumidifier, press the on/o button first, and then unplug the power cable from
the electrical outlet.
Setting the Timer
1. Press the button to set a timer from 1 to 24 hours, or turn it o. The timer will cycle through the times
available in hour increments, from 1-24h, then o. When the timer is o, the icon will switch o.

Ivation IVACDEH15P Specifications

Power

rated voltage	120V
rated frequency	60Hz
power consumption	~200W

Performance

rated dehumidification capacity	14.7 pints/day (7 L/day)
set humidity range	40% – 70%

Capacity

water tank capacity	3.8 pints (1.8 L)

Weight and Dimensions

dimensions	10.9" W x 7.1" D x 18.3" H (27.7 x 18 x 46.5 cm)
net weight	21.8 lb. (9.89 kg)