Settings
6 720 643 409 (2010/03)
68
B Go back to the previous field by using .
B Press the menu dial in the last setting field to save
settings
Hot water circulation takes place every day during the
set periods.
> Protective anode installed
1)
value set during Start-up
Change the value if there has been a change since start-
up.
B Change to No if no anode exists.
Normally, there is an anode in the hot water heater in
order to protect it against corrosion. If the anode
breaks, it must be fixed to prevent the hot water
heater from being damaged. The control unit alerts
when the anode is broken.
15.3 Holiday
During holidays (absence), the heating can, for example,
be kept at a lower or higher level and hot water
production can be switched off. Start and Stop date,
Room temperature and Block hot water production is only
displayed if the holiday function is activated.
> Circuit 1 and hot water
>> Activate holiday function
>> Start date
>> Stop date
B Set start and stop date for the desired period. Format
yyyy-mm-dd.
The period starts and ends at 00:00. Both the start
and end date are included in the period.
B Terminate the period prematurely by indicating No in
the menu Activate holiday function.
>> Room temperature
B Set the room temperature that should apply to the
circuit during the period.
>> Copy to all heating circuits
>> Block hot water production
> Circuit 2, 3...(optional)
>> Activate holiday function
>> Start date
>> Stop date
>> Room temperature
B Set the values in the same way as for Circuit 1 and
hot water.
15.4 Energy measurements
> Generated energy
This displays Generated energy in kWh divided into
Heatingand Hot water.
> Consumption electric additional heat
This displays Consumption electric additional heat in
kWh divided into Heating and Hot water.
Factory setting
1)
Alternative Yes/No
Tab. 106Anode installed
Factory setting No
Alternative No/Yes
Tab. 107Holiday function
Factory setting 17 °C
Lowest value 10 °C
Highest value 35 °C
Tab. 108Room temperature, holiday
Factory setting No
Alternative Yes/No
Tab. 109Copy circuits
Factory setting No
Alternative Yes/No
Tab. 110Block hot water
To Next Page
Loading...
Need help?
General
