4 CONTROLS
en-24
4.3 OPERATOR CONTROLS____________________________________________________
K. Forward Traction Pedal
Press forward traction pedal down to move the mower
forward. The further the pedal is pressed, the faster the
mower will travel.
L. Reverse Traction Pedal
Press reverse traction pedal down to move the mower
in reverse. The further the pedal is pressed, the faster
the mower will travel.
M. Brake Pedal
The brake pedal is used to activate the traction motor
brake.
Press the pedal slightly to act as a service brake.
Traction motor brake will apply resistance to the motor
and place mower into regen mode. Press pedal all the
way down to fully engage the brake.
See Section 4.7
and 4.8.
N. Steering Wheel Tilt Lever
Push lever down to release steering column. Tilt
column up or down to position desired. Release lever
to lock steering column in place.
P. Seat Adjustment Lever
Pull lever up and slide seat forward or backward.
Release lever to lock seat in place.
R. 12 Volt Accessory Outlet
Located inside armrest storage compartment. Allows
operation of approved 12 volt accessories and
attachments. To prevent excessive battery drain, only
use 12 volt outlet with engine running.
Only functional
on hybrid powered mowers.
S. Choke (Gas Hybrid Mower Only)
Pull the choke control knob out to close the choke
plate when starting a cold engine. A warm engine
may not require “Choking” to start. Slowly push
choke lever in once engine starts.
Figure 4B
CAUTION
Never adjust tilt steering while mower is moving. Stop
unit before adjusting.
CAUTION
Never adjust seat while mower is moving. Stop unit
before adjusting.
CAUTION
The 12 volt Accessory Outlet circuit is protected by a
10 amp fuse. Do not attempt to use attachment(s) with
a combined power rating greater than 120 watts.
Engine must be running when using accessory outlet.
To prevent the risk of burns or fire do not replace 10
amp fuse with a higher amperage rating fuse.
To Next Page
Loading...
Need help?
General
