ADJUSTMENTS 11
en-87
11.15HOOD STOPS _____________________________________________________________
1. Adjust position of hood stop bumpers (Z) as required
so hood contacts bumpers with approximately 1/8 in.
(0.3 cm) clearance between hood and cowlings.
2. Adjust left and right side bumpers as required so
hood is level.
3. Test operation of hood latch. Hood latch must be
able to latch hood.
Figure 11N
11.16LIFT STOPS ______________________________________________________________
If the lift actuators make a ratcheting sound when being
raised, lift stop adjustment may be required. Lift stops
must be adjusted with lift system in Mow Mode. Refer to
Safety & Operation manual, Section 4.9.
1. Loosen left and right reel stop hardware (AA).
2. Start mower, turn mow switch on, and fully raise
reels. Shut off mower.
3. Adjust left reel stop bracket (AB) so reel stop pin
(AC) is resting in bracket slot. Tighten hardware
(AA). If additional adjustment is needed, adjust
position of stop pin (AC).
4. Repeat for right reel stop bracket.
5. Loosen hardware (AD). Adjust left reel bumper and
bracket (AE) to contact left reel in fully raised
position.
6. Repeat bumper adjustment for right reel bumper.
7. Loosen hardware (AF). Adjust left side bumper (AG)
to contact center reel in fully raised position.
Hardware (AF) is located on battery tray on battery
power modules and buffer battery tray on hybrid
power modules.
8. Loosen hardware (AJ). Adjust right side center reel
bumper (AH) to contact center reel. Adjust center
bumper (AK) if required.
Figure 11O
Figure 11P
Figure 11P
To Next Page
Loading...
Need help?
General
