4 CONTROLS
en-32
4.6 FREQUENCY OF CUT ______________________________________________________
The FOC (Frequency of Cut) is the distance, in inches
(cm), the machine travels forward between reel blades
contacting the bedknife. The FOC can be adjusted either
by changing the Fixed FOC setting or by changing the
maximum mow speed and the fixed reel speed on the
LCD display.
Adjust FOC with Fixed FOC setting
Changing the FOC setting to a value other than 0 will
enable the fixed FOC mode and overrides the reel speed
setting. As mower travel speed increases or decreases,
reel speed will automatically adjust as required to
maintain set FOC.
Adjust FOC with Reel Speed Setting
1. Using the FOC charts, determine the maximum mow
speed and fixed reel speed required for the desired
FOC.
2. Switch to Maintenance Mode. [Section 4.7]
3. Set fixed FOC setting to 0.
4. Set desired Maximum Mow Speed.
5. Set desired Fixed Reel Speed.
NOTE: Mow speed is measured in mph (kph), FOC is
measured in inches (millimeters).
NOTICE
When using a fixed FOC setting, the reels will not turn
if the mower is not moving.
Maximum mow speed may be lower than what is set
in the LDU when using a very low FOC.
To Next Page
Loading...
Need help?
General
