4 OPERATION
16
4.8 TOWING / TRAILERING _____________________________________________________
If the tractor experiences problems and must be shut down
and removed from the area, it should be loaded onto a trailer
for transport. If a trailer is not available, the unit can be
towed slowly short distances.
Use care when loading and unloading tractor. Fasten tractor
to trailer to prevent tractor from rolling or shifting during
transport.
Before moving tractor without starting engine, open tow
valve. The tow valve permits moving the tractor without
starting the engine and prevents possible damage to
hydraulic components.
The tow valve (A) is located on the hydraulic drive pump to
the rear of and above the left front tire. To open valve, turn
the valve counterclockwise 90° to the horizontal position.
Before towing make sure cutting units are raised. If they
cannot be raised, remove them from the tractor.
Turn valve clockwise 90° to the vertical position after towing.
NOTE:
Do not exceed 3 MPH (4.8 KPH) while towing. Long
distance towing is not recommended
.
Figure 4C
4.9 HILLSIDE OPERATION _____________________________________________________
The tractor has been designed for good traction and stability
under normal mowing conditions; however, use caution
when operating on slopes, especially when the grass is wet.
Wet grass reduces traction and steering control.
1. Always mow with the engine at full throttle but reduce
forward speed to maintain the proper cutting frequency.
2. Mow along the side of the hill (horizontally), starting at
the bottom and working upwards. This allows the
tractor to negotiate the slope without mowing in a
downhill direction.
3. If the tractor tends to slide or the tires begin to “mark”
the turf, angle tractor into a less steep grade until
traction is regained or tire marking stops.
4. If tractor continues to slide or mark the turf, the grade
is too steep for safe operation. Do not make another
attempt to climb, back down slowly.
5. When descending a steep slope, always lower
implements to the ground to reduce the risk of tractor
overturning.
Correct tire pressure is essential for maximum traction. See
Parts & Maintenance manual.
Operating
Position
(Vertical)
Tow
Position
(Horizontal)
A
WARNING
To minimize the possibility of overturning, the safest
method for operating on hills and terraces is to travel
across the face (horizontally), not up and down the face
of the slope (vertically). Avoid unnecessary turns, travel
at reduced speeds, and stay alert for hidden hazards.
CAUTION:
Do not operate this tractor on slopes
greater than 12.6°.
! !
!
To Next Page
Loading...
Need help?
General
