MAINTENANCE 9
en-66
9.22 MOWER STORAGE ________________________________________________________
General
• Clean the mower and lubricate. Repair and paint damaged or open metal.
• Inspect the mower, tighten all hardware, replace worn or damaged components.
• Drain and fill the radiator.
• Clean the tires and keep the mower so that the load is not on the tires. If the mower is not on the jack stands,
check tires at normal intervals and add air when needed.
• Keep the mower and all accessories clean, dry and protected from the elements. Never keep the mower near an
open flame or spark which can cause ignition of the fuel or fuel vapors.
Battery
• Remove, clean and keep the battery in the upright position on a surface that is not metal in a cool dry location. To
prevent increased battery discharge, do not keep the battery on a metal surface.
• Check and charge the battery every 60 to 90 days.
• Keep the battery in a cool dry location. To decrease the self discharge rate, the temperature must not be more
than 80° F (27° C) or less than 20° F (-7° C).
Engine
• While the engine is warm, remove the drain plug, drain the oil from the crankcase and change the oil filter. Install
the drain plug and fill the engine with oil. Torque the drain plugs to 22 ft. Lb. (30 Nm).
• Clean the outside surface of the engine. Paint bare metal or apply a thin layer of rust preventative oil.
• Add a fuel conditioner or biocide to prevent the fuel to become a gel or bacteria in the fuel. See your fuel supplier
for instructions. Drain water from water separator.
Cutting Units
• Completely clean the cutting units. Repair and paint any damaged or bare metal surfaces.
• Lubricate all grease fittings and friction points.
• Apply a thin layer of rust preventative oil to the sharpened edges of the reel and bedknife.
After Storage
• Check and install the battery. If necessary, charge the battery.
• Check or service the fuel filter and air cleaner
• Check the radiator coolant level.
• Check the level of engine oil and hydraulic fluid.
• Fill the fuel tank with fuel. Bleed the fuel system.
• Make sure the tires are correctly inflated.
• Remove all oil from the reels. Adjust the cutting height.
• Start the engine at 1/2 throttle. Allow the engine to become warm and lubricated.
CAUTION
The cutting unit reels can have sharp edges. To prevent injury, use caution when you service or hold the blade.
WARNING
Never operate the engine without enough ventilation or in an enclosed area. The carbon monoxide in the exhaust
fumes can increase to dangerous levels.
!
!
To Next Page
Loading...
Need help?
General
