10 ADJUSTMENTS
en-69
10.5 ARMREST HEIGHT ADJUSTMENT ___________________________________________
The armrest has four available height settings for the operator.
To adjust standard seat armrest height:
1. Stop the engine and remove the key.
2. Remove the armrest hardware from the bracket on
the right side of the seat.
3. Lift or lower the armrest as needed until another set of
holes in the armrest bracket align with the seat
bracket. Assemble the armrest hardware.
4. When you adjust the height, check the wiring harness
connector for a tight connection to the mower
harness.
To adjust premium seat armrest height:
1. Stop the engine and remove the key.
2. Release the cam levers on the right side of the seat.
3. Move the armrest toward the rear of the mower. Lift or
lower the armrest until the upper bolt is in the
necessary slot in the seat bracket. Tighten the cam
levers.
4. When you adjust the height, check the wiring harness
connector for a tight connection to the mower
harness.
Armrest
Hardware
Armrest
Hardware
Cam
Levers
Armrest
Slots
To Next Page
Loading...
Need help?
General
