6 OPERATION
19
6.9 MOWING_________________________________________________________________
To mow:
1. Press lift lever (F) forward to lower decks. Engage
power take-off (K) to start blades and depress trac-
tion pedal slowly to begin mowing.
The correct operating speed depends on the height,
density, type of grass and terrain being cut.
2. To raise decks first turn PTO switch (K) off to stop
blades, then pull and hold lift lever (F) back. Always
stop and raise decks when crossing paths or
roadways.
3. Plan your cutting pattern to avoid unnecessary turns
so you will mow as straight as possible.
a. For extremely tall grass, first cut at a higher level
then lower decks to the desired cutting height.
b. Slow down when turning, operating in tight areas,
mowing on hillsides or over rough terrain.
6.10 AFTER OPERATION _______________________________________________________
1. Park the mower on a flat, level surface. Fully lower
the implements to the ground, engage parking brake,
stop the engine, and remove key from ignition switch.
2. Grease and lubricate all points if required, wash the
cutting unit and mower after each use.
Note: Do not wash a hot or running engine. Use
compressed air to clean the engine and radiator fins.
3. Fill the fuel tank with fresh, clean fuel. Be sure to
reinstall and tighten fuel cap.
Read Parts and Maintenance Manual for proper care
and cleaning procedures.
WARNING
To prevent serious injuries, keep hands, feet, and
clothing away from cutting unit when the blades are
moving.
NEVER use your hands to clean cutting units. Use a
brush to remove grass clippings from blades. Blades
can be sharp and could cause injuries.
To clear obstructions from cutting unit, disengage
power take-off, engage parking brake, stop engine,
and remove key from ignition switch then remove
obstruction.
CAUTION
Never raise decks with the blades turning. Always
disengage power take-off.
To Next Page
Loading...
Need help?
General
