J-100
9.0 Control Functions
9.1 Control Panel
A. LED Display: Can
display current water
temperature (default
display), water tem-
perature set point,
selected ltration/heat-
ing mode, and error
messages.
B. Heat Indicator: Lit when heater is on.
C. Jets 1 Button: Turns jets pump #1 on and off. Press once for low
speed; press a second time for high speed; press a third time to turn
pump off.
D. Jets 2 Button: Turns high-speed jets pump #2 on and off. Press
once to turn pump #2 on; press a second time to turn pump #2 off.
E. Light Button : Turns accent lights on in one of three random modes
or one of seven solid colors. Refer to Section 10.3 (page 23) for
details.
F. Warmer ( ) Button: Increases water temperature set point.
G. Cooler ( ) Button: Decreases water temperature set point.
Operation Details
• Temperature Adjustment: 65 to 104°F (18 to 40°C). Factory default
setting is 100°F (38°C).
• LED light system: All LED lights run for 1 hour and then automatically
shut off.
• Jets 1/Jets 2 Button Operation: Jets run for 20 minutes when
activated, then turn off automatically to conserve energy. Simply
press either jets button to continue operation for an additional 20
minutes.
A
B
1
2
C
D
E
G
F
20
To Next Page
Loading...
Need help?
General
