Operating Instructions
Now that the spa is in place, you are probably eager
to take advantage of its unique designed-in features—
especially the patented hydromassage performance.
Besides being a beautiful addition to your indoor decor
or outdoor landscaping, your Jacuzzi Whirlpool Bath spa
will provide you with the ultimate in spa pleasure.
Familiarize yourself with the operation of the elec-
tronic control panel, as described on pages 12-16 of this
manual. Access under the spa (behind the skirts) is not
required for normal operation.
WARNING: Do not turn ON power to the spa unless it
is filled with water to the normal water level. Refer to
water line indicator mark on skimmer frame. When-
ever the power is ON, the system will activate even
though no controls are operated. When there is not
sufficient water in the unit with the spa’s motor/pump
actuated, the circulation pump and heater could be
irreparably damaged. Not heeding this caution will
nullify the warranty. In addition to damaging the unit,
operating the spa with insufficient water could cause
a fire.
8
Initial Instructions
Using a garden hose, fill the spa with water to the
water line indicator mark on the skimmer frame.
At the house service panel, turn ON the circuit
breaker or switch that controls the electrical service to
your spa. Make sure there is no other appliance on that
circuit.
Electrical
Your spa must be installed in an electrical circuit
protected with a Ground Fault Circuit Interrupter (GFCI)
(refer to Electrical Requirements). At initial start-up and
before each use thereafter, with power ON, push the
GFCI test button. The reset button should pop out. Push
this button in to reset. If the interrupter fails to operate
in this manner, there is a ground current flowing or a
device malfunctioning, indicating the possibility of elec-
tric shock.
DANGER: Turn OFF power and do not use the spa
until the source of the problem has been identified
and corrected.
OPERATION
To Next Page
Loading...
Need help?
General
