12
Remote Controller (Pinnacle, Quantum and Triton)
OPERATION
The remote controller works in conjunction with the built in controller. To use the remote controller, point the front of
the remote toward the sensor on the spa wall (locations shown below).
LIGHT
BUTTON
BLOWER BUTTON
JETS BUTTON
POINT
TOWARD
SENSOR
Blower: Starts or stops the blower for
aeration in the spa (blower takes a few
seconds to activate). When both jet
pumps are operating, the blower
is disabled.
The blower will also automatically stop after 30
minutes of operation.
Light: Press the button once to activate the
highest setting, again for the medium set-
ting and again for the lowest setting. A
fourth press of the button will turn the light
OFF.
The lights automatically turn OFF after 4 hours of
operation.
The remote batteries have an anticipated life of 3 years,
depending on usage.
If batteries need to be replaced, please call (714) 438-
3280 for return authorization.
Return unit to: Balboa Instruments, Inc.
3598 Cadillac Ave.
Costa Mesa, CA 92626
Jets Control: Press this button once to
activate a jet pum on one side of the spa;
press it twice for both pumps to operate
simultaneously for maximum effect. Press it a third time
to turn off the jet pumps. This button does not affect the
filter pump operation which is an independent function.
When the jet action mode is started, it will automati-
cally stop after 30 minutes of operation.
OPERATION
LOCATION OF SENSOR
TRITON
LOCATION OF SENSOR MANUAL
CONTROLLER
QUANTUM
LOCATION OF SENSOR
MANUAL
CONTROLLER
PINNACLE
To Next Page
Loading...
Need help?
General
