User Guide - AXYS
®
UniAmp Power Amplifier Module , Model 700
2.INTRODUCTION
This guide describes the operating procedures for the
AXYS
®
UniAmp 700 power amplifier module.
The UniAmp 700 is a mains-powered power amplifier
module incorporating a DSP (Digital Signal Process-
ing) section. It has a single input and multiple speaker
outputs, the number being model-dependent. The DSP
section acts as a multi-band crossover and also controls
beamforming and beamshaping, per-channel levels,
delays, limiting action, etc.
The DSP may be configured to suit individual applications
and requirements via AXYS
®
’s WinControl software appli-
cation. This level of configuration should not be confused
with the per-model factory hardware configuration
referred to in the next section (Applicable models and
variants). WinControl also permits constant monitoring
of all units in a multiple-cabinet system during operation.
WinControl is available as download from
http://www.duran-audio.com/software/WinControl.html.
This guide does not cover any aspects of the host loud-
speaker system or installation thereof; these topics are
the subject of a separate Installation Manual, supplied
with each loudspeaker.
APPLICABLE MODELS AND VARIANTS
The UniAmp 700 is the power amplifier module fitted as
standard to the following AXYS
®
powered loudspeakers:
Target range:
U-16
Scope
G2
range:
T-2112
T-2115
UB-25
Source
G2
range
T-07
B-07*
IMPORTANT –Each UniAmp 700 is configured
in the factory to suit the loudspeaker type in
which it is to be installed. These configuration differences
are at hardware level and are significant, and it is NOT
possible to interchange UniAmp 700 modules between
loudspeaker types.
The UniAmp 700 has no user-serviceable parts, and no
attempt should be made to remove a module from its host
enclosure. Please contact your AXYS
®
distributor in the
event of faulty operation.
*Note that model B-07 can also be used as part of a Scope
G2
configuration.
200905/UAUG_v1.0 5
To Next Page
Loading...
Need help?
General
