JBL GT-BassPro12 User Manual

2
INTRODUCTION
Thank you for choosing the JBL
®
GT-BassPro12 powered automotive
subwoofer. The GT-BassPro12 has been designed to deliver great
bass performance from a compact, easily installed powered subwoofer
enclosure.
To get the best performance from your GT-BassPro12, we strongly
recommend that installation be entrusted to a qualified professional.
Although these instructions explain how to install the GT-BassPro12 in a
general sense, they do not show specific installation methods that may be
required for your particular vehicle. If you do not have the necessary tools
or experience, do not attempt the installation yourself. Instead, please
ask your authorized JBL car audio dealer about professional installation.
In order that we may better serve you should you require warranty
service, please retain your original sales receipt and register your
GT-BassPro12 online at www.jbl.com.
INCLUDED ITEMS
GT-BassPro12
Powered Subwoofer
Remote
Level Control
Mounting
Screws
High-Level Input
Wiring Harness
Remote
Level Control
Cable
INSTALLING THE SUBWOOFER
INSTALLATION WARNINGS AND TIPS
• Always wear protective eyewear when using tools.
• Disconnect the vehicle’s negative (–) battery terminal before starting
the installation.
• Check clearances on both sides of a planned mounting surface. Be
sure that screws or wires will not puncture brake lines, fuel lines or
wiring harnesses, and that wire routing will not interfere with the safe
operation of the vehicle.
• When making electrical connections, make sure they are secure and
properly insulated.
• I f you must replace the GT-BassPro12’s fuse, be sure to use the same
type of fuse and current rating as that of the original.
MOUNTING THE SUBWOOFER
Choose a location for the subwoofer that doesn’t interfere with cargo,
a fold-down rear seat or the trunk lid. The best location is usually a
corner of the trunk or cargo area, as shown in the illustrations. Choose a
mounting location in the front of the vehicle for the remote level control.

JBL GT-BassPro12 Specifications

General

Product type	Pre-loaded subwoofer
Enclosure type	Enclosed
Subwoofer type	Passive subwoofer
Number of drivers	1
Subwoofer peak power	450 W
Subwoofer sensitivity	12 dB
Subwoofer driver diameter	305 mm
Subwoofer frequency range	35 - 120 Hz
Subwoofer crossover frequencies	70 - 120 Hz
Subwoofer driver diameter (imperial)	12 \
Housing material	-

Weight and Dimensions

Width	369 mm
Height	570 mm
Weight	17500 g