16
2.7 Connecting to AC Mains
Connect your amplier to the AC mains power source (power outlet) with the
supplied AC power cord. First, connect the IEC end of the cord set to the IEC
connector on the amplier; then, plug the other end of the cord set to the AC mains.
When properly connected to a live power source, the power LED should illuminate
blue.
WARNING: The third prong of this connector (ground) is an important safety feature.
Do not attempt to disable this ground connection by using an adapter or other
methods.
Ampliers don’t create energy. The AC mains voltage and current must be sufcient
to deliver the power you expect. You must operate your amplier from an AC mains
power source with not more than a 10% variation above or below the specied line
voltage and within the specied frequency range indicated on the back panel of the
amplier. If you are unsure of the output voltage of your AC mains, please consult
your electrician.
2.8 Protecting Your Speakers
It’s wise to avoid clipping the amplier signal. Not only does clipping sound bad, but
it can damage high-frequency drivers. The built-in clip limiter prevents clipping.
Also, avoid sending strong subsonic signals to the amplier. High-level, low-
frequency signals from breath pops or dropped microphones can blow out drivers.
You can switch to the HI-Z mode which, in addition to switching in the output
transformers for 70V and 100V speakers, activates the high-pass lter. The lter
prevents potentially damaging subsonic signals from going to the amplier by
eliminating signals below 70Hz.
2.9 Startup Procedure
Use the following procedure when rst turning on your amplier:
1. Turn down the level of your audio source.
2. Turn down the level controls of the amplier.
3. Power up the amplier. The blue Power LED should be ON.
4. Turn up the level of your audio source to an optimum level.
5. Turn up the Level controls on the amplier until the desired loudness or power
level is achieved.
If you ever need to make any wiring or installation changes, don’t forget to
disconnect the power cord.
To Next Page
Loading...
Need help?
General
