jcb 15c-1 Quick Start Guide

15c-1, 16c-1, 18z-1, 19c-1, 19c-1 PC 17
1
4
2
5
3
6
Park Machine Up
Release Attachment
Disconnect Attachment
Restart Machine
Insert tommy bar
Remove Attachment
Park the machine on firm level
ground. Position the attach-
ment (A) just above the ground
and dozer (B) on the ground.
Start the engine, rest
attachment on the ground
and engage the hydraulics.
Apply downward pressure to
the tommy bar to release the
buckets rear pivot.
Slowly roll the quickhitch in the
direction of the arrow whilst
raising the dipper to release the
front pivot (A).
Stop the engine, remove any
connected hydraulic hoses and
remove the locking pin.
Insert the tommy bar into the
hole of the latch hook.
A Latch Hook B Tommy Bar
C Hole
Attachments
Quickhitch
121 9831/2900-1 121
Figure 104.
A
A Pivot pin
6. Remove the tommy bar from the Quickhitch.
7. Start the engine and carefully rest the attachment on the ground.
8. Slowly roll the Quickhitch back in the direction of arrow and simultaneously raise the dipper arm to release
the attachment’s front pivot pin from jaws.
Mechanical Hitch Unlock System
Standard Attachments
Attachments
Quickhitch
120 9831/2900-1 120
Figure 103.
A
C
B
A Latch hook B Tommy bar
C Hole
WARNING! The attachment will move when released. Stand clear and to one side when releasing the
attachment.
5. Apply a downward pressure on the bar to release the attachment rear pivot pin from the latch hook, allowing
it to swing forward as shown.
Attachments
Quickhitch
122 9831/2900-1 122
Figure 105.
A
B
A Pivot pin B Jaw
Maintenance
Check the operation of the Quickhitch daily.
Examine the Quickhitch daily for broken or missing parts.
Remove any debris from the latch hook locking mechanism.
Grease the Quickhitch daily.
If the Quickhitch is cleaned by high pressure water, always grease it afterwards.
Visually inspect the condition of the hydraulic hoses to the Qucikhitch.
A

jcb 15c-1 Specifications

General

Brand	jcb
Model	15c-1
Category	Excavators
Language	English