6 Please see operator manual for full details.
Tie Down Points
Fig 2
Operation
Transporting the Machine
103 9831/2900-1 103
Figure 89. Method 2
F
G
H
E
E
C D
I
J
A
B
B
A
A Front slew spine tie-down point
C Angle = 41° to 46°
E Angle = 9° to 15°
G Length = 2,499mm to 1,846mm
I Slew ring centre line
B Rear slew spine tie-down point
D Angle = 45° to 50°
F Length = 2,253mm to 1,943mm
H Length = 2,500mm
J Tie down decal
A Front slew spine tie-down point
C Angle = 35° to 46°
E Angle = 9° to 15°
G Length = 2,720mm to 1,943mm
I Slew ring centre line
B Rear slew spine tie-down point
D Angle = 45° to 50°
F Length = 2,499mm to 1,846mm
H Length = 2,500mm
J Tie down decal
Tie Down Position Decal
When transporting the machine one of the following three methods should be used:
Method 1
REFER TO OPERATORS MANUAL TRANSPORTING MACHINE
To Next Page
Loading...
Need help?
General
