jcb 19C-1E Quick Reference Guide

Please see operator manual for full details.
CHARGING LEVELS & CHARGING
The machine is charged using the plug on the right
hand side, as viewed from the rear of the machine.
Note: there is no requirement for the machine power
switch to be turned ON whilst charging.
Note: Only use the Genuine JCB Charge Cable supplied with the machine. Use an
appropriate grounded industrial supply with correct AC (alternating current) input voltage.
If at any time a fault occurs when charging, the status LED light in Fig. 17 (A) illuminates red,
unplug the charging cable and repeat the above steps. If further issues occur, unplug the
charging cable and contact your local JCB Dealer. If there is a fault with the power supply
the status LED will alternate green and red.
19C-1E
A – Battery full charge
indicator
B – Low battery
indicator
A – Charge indicator LED
B – Operating Status
C – Charging socket
D – Charge cable
Fig. 16
Fig. 17
20
1) Connect the charge lead to the mains supply
outlet and to the machine inlet
2) Depress the reset button on the inline RCD*
3) Green status LED light will illuminate at charge
inlet (See (A) in Fig. 17)
1) LED light will pulse when charging
2) LED light will hold green when plugged
in and not charging
4) Machine instrument panel will illuminate and
display state of charge
*for 230V AC mains supply, when using 110V AC, an RCD is not provided

jcb 19C-1E Specifications

General

Battery Type	Manganese laminated Lithium-ion
Battery Rated Capacity	14.8 kWh (3 Pack) 19.8 kWh (4 Pack)
Charging	On-board charger with direct connection from AC mains power supply
Charging Time	110V – 12 hrs 230V – 8 hrs
Fast Charging (Optional)	Off-board charger, with connection to 415V 3-Phase supply Charging time <2 hrs
System Voltage	48V
Motor Type	AC permanent magnet
Motor Power	7 kW continuous 20kW peak
Operating Modes	L – 1200rpm G – 1600rpm H – 1800rpm Auto Kick Up – 2300rpm, 2 speed tracking only
Thermal Limitations	Operation: -10oC to +46oC Charging: -10oC to +40oC