jcb 8040ZTS User Manual

Section 2 - Care and Safety
Safety Notices
Safety Labels
2-12 2-12
9803/9360-4
Safety Labels
Introduction
T1-014_2
!MWARNING
Safety Labels
Safety labels on the machine warn you of particular
hazards. You can be injured if you do not obey the
safety instructions shown.
INT-1-3-11
Safety labels are strategically placed around the machine
to remind you of possible hazards.
If you need eye-glasses for reading, make sure you wear
them when reading the safety labels. Do not over-stretch
or place yourself in dangerous positions to read the safety
labels. If you do not understand the hazard shown on the
safety label, then refer to Safety Label Identification.
Note: The illustration(s) show a typical machine model.
Your machine may look different from the model shown.
Keep all safety labels clean and readable. Replace lost or
damaged safety labels. Make sure replacement parts
include safety labels where necessary. Each safety label
has a part number printed on it, use this number to order a
new safety label from your JCB distributor.

jcb 8040ZTS Specifications

General

Brand	jcb
Model	8040ZTS
Category	Construction Equipment
Language	English

Summary

Section 1 - General Information

About this Manual

Details on using the service manual, models, and sections.

Identifying Your Machine

Information on machine identification plates and serial numbers.

Standard Torque Settings

Specifications for fastener torque and hydraulic connections.

Hydraulic Connections

Torque settings for BSP and SAE hydraulic fittings.

Service Tools

Numerical list of special tools with section references.

Service Consumables

Details on sealants, adhesives, and cleaning agents.

Terms and Definitions

Explanation of hydraulic schematic colour codes.

Section 2 - Care and Safety

Safety Notices

General warnings, DANGER/WARNING/CAUTION definitions.

General Safety

Operator responsibilities, work site safety, clothing, alcohol.

Operating Safety

Precautions for machine condition, limits, exhaust, work sites.

Maintenance Safety

Safety during repairs, fluids, electrical circuits, working under machine.

Safety Labels

Explains the purpose and location of machine safety labels.

Section 3 - Maintenance

Prepare the Machine for Maintenance

Procedures to safely prepare the machine for service.

Cleaning the Machine

Procedures for cleaning machine body, tracks, and components.

Checking for Damage

Inspecting machine structure, seat belt, hoses, and electrical circuits.

Greasing

Lubrication points for pivot pins, slew ring, and access panels.

Engine Maintenance

Covers oil, filter, cooling system, belts, and air filter.

Fuel System Maintenance

Details on fuel filters and bleeding the fuel system.

Hydraulic System Maintenance

Information on pressure release and fluid checks.

Tracks and Running Gear Maintenance

Procedures for track gearbox oil and tension.

Service Requirements

Overview of routine maintenance and owner support.