DECOMMISSIONING OF THE MACHINE
After the machine is decommissioned it can be
disposed of with normal industrial waste.
Service information
Please note that the following parts of this
product are subject to normal or natural wear
and that the following parts are therefore also
required for use as consumables.
Wear parts*: Carbon brush, saw blade, table
inserts, dust bags, batteries,
* Not necessarily included in the scope of
delivery!
Electrical connection
The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions.
The customer‘s mains connection as well as
the extension cable used must also comply
with these regulations.
Important information
In the event of an overloading the motor will
switch itself off. After a cool-down period (time
varies) the motor can be switched back on
again.
Damaged electrical connection cable
The insulation on electrical connection cables is
often damaged.
This may have the following causes:
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been
improperly fastened or routed.
• Places where the connection cables have
been cut due to being driven over.
• Insulation damage due to being ripped out
of the wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables
must not be used and are life-threatening due
to the insulation damage.
Check the electrical connection cables
for damage regularly. Make sure that the
connection cable does not hang on the power
network during the inspection.
Electrical connection cables must comply with
the applicable VDE and DIN provisions. Only
use connection cables with the marking „H 07
RN“.
The printing of the type designation on the
connection cable is mandatory.
AC motor
• The mains voltage must be 230 V~
• Extension cables up to 25 m long must have
a cross-section of 1.5 mm2.
Connections and repairs of electrical
equipmentm may only be carried out by an
electrician.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate
Storage
Store the machine and its accessories in a
dark, dry and frost-free place, inaccessible to
children. The ideal storage temperature is
between 5 and 30˚C.
Store the power tool in its original packaging.
Cover the power tool to protect it from dust
and humidity.
Keep the operating manual with the power
tool.
To Next Page
Loading...
Need help?
General
