JCB-PW7532P
Instruction & User Manual
16
Pre-Operation Checks
Oil Level
Check Engine Oil Level Check the engine oil level with the engine stopped and in a level position.
> Remove the oil filler cap/dipstick and wipe it clean.
> Insert and remove the dipstick without screwing it into the filler neck. Check the oil level shown on the dipstick.
> If the oil level is low, fill to the edge of the oil filler hole with the recommended oil .
> Screw in the oil filler cap/dipstick securely.
Air Filter Inspection
Oil Filler Cap / Dipstick
Oil Inlet
Maximum Level
Minimum Level
Paper Filter
Element
Foam Filter
Element
Air Filter
Cover
A dirty air filter will restrict air flow to the carburettor, reducing engine
and pump performance.
Remove the Air Filter Cover and inspect the filters. Clean or replace
dirty filter elements. Always replace damaged filter elements.
Reinstall the air filter and air cleaner cover. Be sure all the parts shown
below are in place. Tighten the wing nut securely.
WARNING! Operating the engine without an air filter, or with
a damaged air filter, will allow dirt to enter the engine,
causing rapid engine wear. This type of damage is not covered
by the Distributor’s Limited Warranty.
To Next Page
Loading...
Need help?
General
